Hey guys, I figured I'd start a running thread for this project and update it every time I complete a new scan. My dad gave me an old electric screwdriver that no longer worked so I figured I'd take it apart, scan all the pieces, and reassemble it in 3D. It has a lock switch in the middle that allows it to change the angle of the handle, so that made it interesting to me.
I first scanned the whole thing together in low res so I had a reference base and so I could match up the exterior cylindrical pieces that are normally difficult to align. Once I had this base, I took it apart and have started the process. First, here's that low res base:
And some of the first few pieces scanned:
The spring is the only thing that I couldn't scan because it was just too darn small.
